|
FINALIZE RESTORATION.
FIX WIRING AND PLUMBING.
FIX SUSPENSION AND EXHAUST.
CLEAN UP INTERIOR AND EXTERIOR.
TEST DRIVE.
The Plymouth Road Runner was a muscle car built by the Plymouth division of the Chrysler Corporation in the United States between 1968 and 1980. In 1968, the first muscle cars were, in the opinion of many, moving away from their roots as relatively cheap, fast cars as they gained options. Although Plymouth already had a performance car in the GTX, designers decided to go back to the drawing board and reincarnate the original muscle car concept. Plymouth wanted a car able to run 14-second times in the quarter mile (402 m) and sell for less than US$3000. Both goals were met, and the low-cost muscle car hit the street. The success of the Road Runner would far outpace the upscale and lower volume GTX, with which it was often confused.
1970
1970 brought new front and rear end looks to the basic 1968 body, and it would prove to be another success. Updates included a new grille, leather seats, hood, front fenders, quarter panels, single-piston Kelsey-Hayes disc brakes (improved from the rather small-rotor Bendix 4 piston calipers of ’68 – ’69 ), and even non-functional scoops in the rear quarters.[3] The design and functionality of the Air Grabber option was changed this year to increase both efficiency and the “intimidation factor”. A switch below the dash actuated a vacuum servo to slowly raise the forward-facing scoop, exposing shark-like teeth on either side. “High Impact” colors, with names like In-Violet, Moulin Rouge, and Vitamin C, were options available for that year. The 1970 Road Runner and GTX continued to be attractive and popular cars. The engine lineup was left unchanged although a heavy-duty three-speed manual became the standard transmission, relegating the four-speed to the option list along with the TorqueFlite automatic. This was to be the second and last year of the Road Runner convertible, with only 834 made. These cars are considered more valuable than the 1969 version due to a better dash, high impact colors and more options including the new high-back bucket seats shared with other Chrysler products which featured built-in headrests.
The relatively popular 440 Six Barrel was relegated to option status for 1970. The 1969 “M” Code Edelbrock aluminum intake was replaced by a factory-produced cast iron piece; however, due to a porous casting, there was a recall early in the iron intake-equipped 440+6 run, and these were supposed to be replaced with the more-desirable Edelbrock intake from the year prior.
|
